Customized Digital Dual Gauge with Alarm 52MM Water Level+Sewage Level Meter for Water/Sewage Level Sensor 0-190ohm HTG Boat Car 12V24V
NOTE: The Gauge sell single, The Sensor is sell single , if you choose gauge , the package is not included sensor , if you choose sensor , the package is not included gauge ,
2022 New 52mm Universal 2 in 1 Dual Gauge
Application: Marine Boats/Truck/Bus/Motor Home/Hot Rod/Generators
About the gauge:
The device works, with a little delay (about 20 seconds) of changes in the readings. Apparently, it is done in order not to react to the splash of water in the tank.
Feature:
– 52mm diameter Two in One Gauge show with easy installation
– Programmable Input Resistance Ohm Signal to adapt different fuel /water/temperature sensor
0-190Ω, 0-180Ω, 10-180Ω, 240-33Ω, 240-30Ω
– High Resolution View under sunshine
– Installation Diameter: 52mm (2inch)
– Reverse polarity protection and anti-fogging performance
– Working Voltage:12V/24V
– Working temperatures: – 40 to 85°C
– IP66 Waterproof
INSTALLATION GUIDE
1. Cut an Φ52mm (2-1/16") hole in the panel (II) allow a clearance of 55mm (2 3/16”). behind the panel.
2. Remove fastening ring (I), insert gauge from front. Tighten gauge (III) using fastening ring ( I)
3. Connect cables according to the diagram/label.
Setting Menu：“Unit” “R 1” “R 2”
1.Hold & Press the button, Power On Gauge, the LED screen will show Switch Show
Unit, R1, R2
2.Unit
Fuel Gauge, Water Level, HTG Sewage Level: %
Water temperature: ℃ or ℉
3.R1—Configure Top Row Signal Range
Press Button to switch 000 ~006
For example, LED will show 001, which means 0~180ohm, then release the button and wait digital flash to complete to save setting
4.R2—Configure Top Row Signal Range
Press Button to switch 000 ~006.
For example, LED will show “002” , which means 10~180ohm, then release the button and wait digital flash to complete to save setting
Package:1PCS Gauge+Manual+Cable( not include sensor)
this package is not included sensor , just the gauge
Sensor supporting Customized , if you need customized , please contact to us
Water Level Sensor:
– Resolution range: 21 mm
– Signal: 0-190ohm(can customized)
– Working volt:9-32VDC
– Operating current: ≤60mA
– Operating temperature: -30~+75℃
– Storage temperature: -40~+85℃
– Sensor Length: 100mm-600mm(can customized)
Package:1 X Water Level Sensor+Manual( not include gauge)
this package is not included gauge,
Sewage Level Sensor:
– Resolution range: 21 mm
– Signal: 0-190ohm(can customized)
– Working volt:9-32VDC
– Operating current: ≤60mA
– Operating temperature: -30~+75℃
– Storage temperature: -40~+85℃
– Sensor Length: 100mm-600mm(can customized)
Package:1 X Sewage Level Sensor+Manual
this package is not included gauge,
