Specification:
Gauge tests pressures ranges from 0 – 3.5 bar
Designed to fit most major car brands from Europe, Japan and the United States
Adapter for Benz, Jeep, GM (Buick)
Adapter for Peugeot, Subaru, Chrysler, Acura, Mitsubishi, Nissan, Mazda, Toyota, InfAdapter for GM (Cadillac)
initi, Geo, Suzuki, Isuzu, GM (Nova, Spectrum, Sprint)
Adapter for Honda, Toyoyta, Suzuki, Mitsubishi, Chrysler, Acura
Adapter for Benz (ML-Class), GM (Achiva, Skylark, Gramd AM-1992-2002)
Adapter for Volvo, Saab, Sterling, Citron, Renault, Fiat, Alfa, Jeep
Adapter for VW (Jetta, T4, 1996-Passat, Golf)
Adapter for Audi (A4, A6), BMW 345, VW (Passat 1997-2002)
Adapter for BMW
Adapter for Audi, VW
Adapter for Ford, International, GM, Rover
Adapter for Benz
Package List:
1 x spanner
1 x Pressure testing pump with gauge
1 x Temperature gauge
4 x chrome steel adapters
8x strong nylon adapters.
Instructions not included
Operation instruction
1. Open the water tank (Before opening the cover, make sure the water tank is cool.
2. Select the right tank head.
3. Fasten the water tank while checking the rubber ring is fully compliant.
4. Insert the quick connector into the water tank probe.
5. Take out the hand pump set and press until the pressure indicates approximately 15-20 psi
6. Check the pressure gauge.
6.1 If the pressure gauge pointer remains unchanged for several minutes, it indicates that the system can be used normally.
6.2 If the pointer drops, it indicates that the system is cracked due to pressure damage.
6.2.1 Check whether the pipes in the water tank leak, and repair the pipes according to the leakage position
6.2.2 Check the condition of the rubber ring
6.2.3 Retest to ensure that the repaired system can be used normally
7. After the test is complete, relieve the pressure from the pressure relief valve to the pressure gauge to zero
8. Collection after use
8.1 The water tank probe is inserted into the fast head, pressurized several times, and the residual water gas in the pipe of the manual pump group can be stored.
8.2 Inject the pneumatic oil into the inlet hole at the tail of the hand pump set to lubricate the piston in the tube. Then insert the side head of the water tank, pressurize several times, and discharge the residual pneumatic oil in the pipe of the manual pump group.
Antifreeze replacement operation instructions
1. Empty the tank completely
2. Open the hood of the car and hang the hook in place
3. Connect the universal rubber joint to the water tank or choose a suitable joint to connect the water tank
4. Make sure all switches are off, connect the thin pipe to the rat tail connector and then connect it to the tank
5. Connect the intake pipe, open the intake switch, connect the air pump, and vacuum when the pressure reaches 20~-25lnhg(-50~-60cmhg), the intake switch will be closed
6. Connect the antifreeze pumping hose to the table body and put the other end into the antifreeze container. The interface must be completely submerged below the water level.
